DataComm 45-0020-WH Manual download pdf (Page 1)

Instruction / Installation Sheet

DataComm Electronics 45-0020-WH Recessed Commercial Grade Low Voltage

Cable Plate with 20 Amp Recessed Power

Use Data Comm Electronics new Recessed Commercial

Grade Low Voltage Cable Plate with 20 Amp Recessed

Power to install low voltage cables behind your flat panel

TV, your amplifier or other audio and video devices.

The 45-0020-WH Recessed Commercial Grade Low

Voltage Cable Plate with 20 Amp Recessed Power can

be installed upright or upside down. Please read all

instructions before installing this product.

To Install 45-0020 Recessed Commercial Grade Low

Voltage Cable Plate with 20 Amp Recessed Power

with a Flat Panel TV Bracket

For retrofit work, determine the location of your flat panel

TV mounting bracket. Using the template supplied (see

back of instruction sheet), trace the opening needed.

Using a drywall knife cut a hole in the drywall the size of

the template. Insert a single gang retrofit workbox (like

one shown in picture). Securely fasten the workbox to

the wall. Switch the appropriate circuit breaker OFF or

remove fuse(s) before wiring. Run a source of power to

this workbox. Connect hot line (black) wire to brass

colored terminal or screw and neutral (white) wire to silver

colored terminal or screw. Be sure to connect grounding

(green) or bare grounding wire to green colored terminal

screw (see Figure 1). For shock protection, this UR, UL

recognized component receptacle must be properly

grounded. Caution – use copper wire only with this

receptacle.

Once you have wired the receptacle, begin by inserting

receptacle portion of the plate into the retrofit work box.

Once the entire recessed plate is flush to the wall, using

the two white screws supplied, screw the receptacle

portion of the plate to the work box.

Next, screw down the screws with wings. These wings

will fasten tightly against the back of the drywall. Switch

appropriate circuit breaker ON or insert fuse(s). Plug all

necessary video and audio cables. Install your flat panel

TV mounting bracket per the flat panel TV bracket

manufacturer’s instructions. Make sure to read all

instructions.

For new construction installations simply use a new nail

on box and follow all other instructions.

INSTRUCTIONS ARE CONTINUED ON THE BACK

SIDE OF THIS PAGE

DataComm Electronics, Inc.

6349 Peachtree Street

Norcross, GA 30071-1725

888.223.7977

770.662.8205

www.

dataco

ect

Figure 1

7/27/10 Rev. 3

Figure 2

Figure 3

1 2

1
TEMPLATE 2

Summary of Contents

Page 1 -

Instruction / Installation Sheet DataComm Electronics 45-0020-WH Recessed Commercial Grade Low Voltage Cable Plate with 20 Amp Recessed Power

Page 2 - TEMPLATE

4-11/16” Instruction / Installation Sheet 45-0020-WH (Continued) WARNING DataComm Electronics products shall be installed and used only as indic

Comments to this Manuals

No comments

DataComm 45-0020-WH Manual Page 1

Browse online or download Manual for Outlet boxes DataComm 45-0020-WH. DataComm 45-0020-WH outlet box User Manual

Summary of Contents

Comments to this Manuals